regarding question posted to you on7/18/2011, we have checked all fuses, which seem to be in working order (low beam headlights not working. fog and high beams do work) on 1999 Ford Mustang GT. no pow … read more Posted December 9, 2016. Evening All, My 2015 MK3.5 Tit X has decided that the drivers side headlight is going to start doing a dance as I drive along, and the dashboard is now telling me that its having a headlight malfunction. I have the full auto light package with the xenons. It is booked with Ford. Hopefully this is covered by the warranty! Position 0 = 11.5v (no engine running) Position 1 = 9.2v. Position 2 = 7.1v. Position 3 = 5.1v. Position 4 = 3.4v. Still the headlights don't adjust when turning the knob inside the car, i have repositioned the pins inside the headlight plug to match the plug on the car. Still nothing, everything else works a treat. Country. 23 Dec 2009. #3. I have a later model with Xenons but the adjustment should be the same. 1 of the screws adjusts the light left to right and the other adjusts up and down. It does take several turns before you notice the lights adjusting. Face the car at a wall approx 20 metres away and adjust until the light hits the wall. As above,need to adjust the offside main beam, i have tried a 6mm too small and 8mm too big, would it be safe to say that the only key i have'nt got a size 7mm will fit the adjuster. MY ST220 ON THE DYNO AT DREAMSCIENCE DREAMSCIENCE DYNO WITH POWER OUPUT. 2006 Final Facelift ST220 in Stardust Silver - Owner is a Fan Boy. Turn on the headlights and observe the beam pattern on the wall. Open the hood and locate the headlight adjustment screws, usually located on the top and side of the headlight assembly. Check if any of the adjustment screws are loose or worn out. If any screws are loose, tighten them using a suitable screwdriver. iLvRjd. 1 Answer. SOURCE: how to change headlight bulb on ford mondeo. Very easy, 2 or 3 minutes. Remove radiator grille. 2 plastic fittings on top, quarter turn and lift out grille. Remove complete headlight. Simply lift out 2 L shape retaining pins. Disconnect lead. Ease out complete headlamp unit. Remove back of headlamp unit to access bulbs. As above,need to adjust the offside main beam, i have tried a 6mm too small and 8mm too big, would it be safe to say that the only key i have'nt got a size 7mm will fit the adjuster. MY ST220 ON THE DYNO AT DREAMSCIENCE DREAMSCIENCE DYNO WITH POWER OUPUT. 2006 Final Facelift ST220 in Stardust Silver - Owner is a Fan Boy. In a situation whereby the new headlight does not glow, there may be corrosion or looseness of the socket. It is also possible that a wiring problem has occurred in the circuit of the headlight. If the problem is socket corrosion, you can get an aerosol electronics cleaner which should be used to spray the socket. Because the projector inside the headlight is constantly moving the wires tend to break, causing issues like this and in the end it fails completely. Check the wires connected to the the switch board of the projector. Seeing you are from the Netherlands, there is also a topic on this issue on Focusclub.nl with pictures of the issue. UK/Ireland Location: Dorset. Posted September 7, 2015. On my old MK2 Facelift with xenons they used to have a little lever inside the headlight to adjust this. You did have to take out the headlight but that was only 1 screw and 2 clips. I used to do it in the car park whilst waiting for the Eurotunnel.

ford focus headlight adjustment not working