A 13 plate will be a Focus MK3. This type of module is not compatible with your MK2. The Focus MK2 and very early MK2.5 did have the old mono Bluetooth/Voicecontrol system. This was basically the 1st generation Bluetooth/Voicecontrol system. This system did only support bluetooth and Voicecontrol. The software of this system can not be updated. Ford Model: MK2 Focus LX Hatchback 1.6 Petrol Manual. Ford Year: 2006. UK/Ireland Location: London. Posted March 27, 2022. I recently realised that the protective cover for the GEM unit in my Mk2 footwell is missing. Am I correct that there should be a black plastic panel with holes in, and another piece of carpet covered plastic that fits on From the schematic available on this site, the radio switched live comes from the Aux contact on the ignition switch, via F108 (or F68 on the Mk2), to the radio connector. No relays or electronics in the circuit, so it must be a wiring or connector problem. A single output from the GEM, which is pulled to ground when on, drives the windscreen FORD FOCUS COMPASS TRANSDUCER MODULE LOCATION REPLACEMENT. COMPASS NOT WORKING FIXIf you need to remove the compass transducer module or replace the compass GEM "programming" is a big word used by dealers to impress when all you do (at least with Forscan and elmconfig) is turn features on or off. A better word would be "configuration". At least here in Europe, GEM / BCM is vehicle model specific and it will work straight away if it's replaced with an identical module (apart from the fobs). Relays location: Relay: Engine compartment relay module #1: ABS pump: R. trailer turn: Rear wiper down: Rear wiper up: L. trailer turn: ABS main: Engine compartment relay module #2: Blower motor: Hi-speed blower: Fog lamp: Front washer pump: Engine compartment relay module #3: Automatic ride control: Instrument panel relay module #4: Dimmer JEAD. If the NGS is NOT able to retrieve the module's backup data from the PCM, it will state to contact the As-Built Data Center. When entering As-Built data to configure the module, the NGS will require that the Vehicle Data located under the VIN number on the vehicles As-Built Data page be entered. The Vehicle Data is used by the FORD ECO MODE (working on my 2010 Mk2.5) Gem Module Auto door locking at 5mph, now i have changed to 10mph with ELMconfig Auto heated window screen at low outside temperature Adjusted curtesy light dimming time Adjusted Walk home lighting time GEM "programming" is a big word used by dealers to impress when all you do (at least with Forscan and elmconfig) is turn features on or off. A better word would be "configuration". At least here in Europe, GEM / BCM is vehicle model specific and it will work straight away if it's replaced with an identical module (apart from the fobs). Posted October 29, 2016. You need at least the following parts: * 4x door handle with integrated sensor. * 4x door wiring loom (with all wiring for Keyless Entry). * Boot lid trim with integrated sensor. * Boot lid wiring loom (with wiring for Keyless Entry). * KVM (Keyless Vehicle Module) that supports both Keyless Start and Keyless Entry. Ford offers just 1 version for replacement of a defective GEM module. This is the latest version which support all of the possible functions. I retrofitted a 2011 Kuga GEM module which supports all possible functions to my Focus MK2 (2005).

ford focus mk2 gem module location