new to this form so may have posted in the wrong place? does anybody know how to replace a power steering pump on a mondeo mk3 2ltr tdci 2003, i have been informed by a garge that the pump is leaking fluid, however due to the clutch needing to be replaced im a bit low on cash so carnt relly for ford mondeo mk5 s-max 2.0 tdci exhaust sensor fuel vapour valve dpf 1890231 (fits: ford mondeo) £104.65 FOR FORD GALAXY 2.0TDCI FUEL PUMP INJECTION CONTROL VALVE PRESSURE REGULATOR (Fits: Ford Mondeo) CJJF. Mondeo mk4.5 2.0 tdci zetec estate, 2011. parking sensors, pet cage, power steering whine. Haven't done anything further since replacing the fuel pump gasket. Still leaks. The yellowish unit controls the amount of fuel fed to the HP pump, is IMV or inlet metering valve. This video shows the replacement procedure of a similar car part on another vehicle CLUB.AUTODOC.CO.UK 1–11 This replacement procedure can be used for: FORD Mondeo Mk4 Estate (BA7) 1.6 TDCi The steps may slightly vary depending on the car design. Important! This tutorial was created based on the replacement procedure for a similar car part Hello. I'm getting both P1169 fuel rail pressure sensor in range but high, and P1168 fuel rail pressure sensor in range but low. The TDCI has a high pressure pump only. It is fitted and driven off the engine itself. You can locate it on the front left of the engine by following the two pipes from the fuel filter on the rear left of the engine bay beside the front suspension mount. It is a fairly big job to remove and I am not sure what looking at it will tell you. Kent. Author. Posted February 18, 2010. On 2/17/2010 at 9:07 AM, FORD-PARTS-CENTRE said: sender £67.37 (pump not included), gasket £9.26. Thanks, I didn't realise that the gasket needed changing as well, to be honest I have never changed one of these but I think it may be cheaper than taking it to ford.

ford mondeo 2.0 tdci fuel pump replacement